phuketmymac
New member
Hi,
That's my first post on this forum, and having big hopes about it ;-)
Kidding...
So I have that 820-3437 board which starts but only get the fan spinning once. Then full blast and I feel that the CPU is getting too fast.
I've the CPU rail PPVVC_S0_CPU which is a stable 1.78V (I was hoping for a higher voltage by a bad regulator or transistors)
I would replace the Bios chip or the clock chip but I will check that first.
However, I have a basic question since I have a few other 820-3437 with burning CPUs... should we assume CPU is dead if it's boiling or is there still hope?
That's my first post on this forum, and having big hopes about it ;-)
Kidding...
So I have that 820-3437 board which starts but only get the fan spinning once. Then full blast and I feel that the CPU is getting too fast.
I've the CPU rail PPVVC_S0_CPU which is a stable 1.78V (I was hoping for a higher voltage by a bad regulator or transistors)
I would replace the Bios chip or the clock chip but I will check that first.
However, I have a basic question since I have a few other 820-3437 with burning CPUs... should we assume CPU is dead if it's boiling or is there still hope?