2andrewd
New member
After replacing the garbage poly-tantalum easter-egged cap this board is stable, however...
(2) errors in ASD OS... (running on a naked logic board FYI)
*TsOP temp. (Palm rest test #1)
"SMC could not initialize this sensor" - I assume trips because the palm rest is absent entirely.
Would the error above constitute "erratic behavior" of a PID loop leading to the following error...
*Failed SMC PID Sensor Check:
"The smc's PID sensor check has been tripped."
Am I anywhere close to to deciphering this correctly?
Thoughts?
(2) errors in ASD OS... (running on a naked logic board FYI)
*TsOP temp. (Palm rest test #1)
"SMC could not initialize this sensor" - I assume trips because the palm rest is absent entirely.
Would the error above constitute "erratic behavior" of a PID loop leading to the following error...
*Failed SMC PID Sensor Check:
"The smc's PID sensor check has been tripped."
Am I anywhere close to to deciphering this correctly?
Thoughts?