820-2850 SMC PID sensor error

2andrewd

New member
After replacing the garbage poly-tantalum easter-egged cap this board is stable, however...

(2) errors in ASD OS... (running on a naked logic board FYI)

*TsOP temp. (Palm rest test #1)
"SMC could not initialize this sensor" - I assume trips because the palm rest is absent entirely.

Would the error above constitute "erratic behavior" of a PID loop leading to the following error...

*Failed SMC PID Sensor Check:
"The smc's PID sensor check has been tripped."

Am I anywhere close to to deciphering this correctly?

Thoughts?
 
Top