820 3332, run without image!

Noguinfor

New member
Hey guys,

i'm working on this board and i need your's bet to repair this board! This board comes with the u8900 resoldered problem!! ok i resoldered the component but i do a fuking mistake!! i don't double check the component after resoldered and the pin 17 + 18 I left them together !! :mad::mad: i test the machine with this pins together and after this the board don't work well.. fan's spin but don't show image..

my question in your's opinion what component i fuck?? u8900 ??
 

2informaticos

Administrator
Staff member
Pufff, you've injected 12.5V on pin18 of U8900 and to U5310 too (pin 3).
U5310 should be fried now, as is powered from 3.3V only.
Change both chips.
You have luck if SMC is still Ok.
 

Noguinfor

New member
Thank Paul and 2informaticos!! U5310 don't have stuff!! ...U8900 problem.. Replaced and the machine work's well!! thank you
 

Noguinfor

New member
Not solved yet!! :mad:, same problem before ressolded the U8900!! The machines turn's on but after 4-5 min fans go maximum speed then shut down!! what could be??
 

2informaticos

Administrator
Staff member
U5310 doesn't appear as NO STUFF on schematic.
The surrounded components not solder too, or U5310 was ripped off?
It is the GPU current sensor; a good reason for SMC sensor error...
 

Noguinfor

New member
Ya U5310 don't appear!! Problem solved!! 1rst i tested with external HD and I noticed that the machine worked well!!! only when i enter in the client SSD, shut down the machine PRAM reset and Problem solved!! thank you one more time!! Posted can be closed
 
Top