thread top ad

Collapse

Announcement

Collapse
No announcement yet.

820-2850 kernel panic even after replacing C9560

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 820-2850 kernel panic even after replacing C9560

    brand new cap. used an old cap from a ps3, tried a ceramic. same stuff. doesn't solve the kernel panic. what could it be?

  • #2
    Can you run ASD?

    Comment


    • #3
      which one should i use here?

      Comment


      • #4
        Asd crashes as soon as I load it. Kernel panic

        Comment


        • #5
          Try flashing BIOS with clean ME.
          Or use Medusa 2 to clean it...

          Comment


          • #6
            Efi version of asd passes it

            Comment


            • #7
              cleaned me.. same issue

              Comment


              • #8
                gah it is an ignition type.. such bs

                tried swapping bios from another machine i have but same old crap. it gives oanic on nvram now
                Last edited by Nick; 11-12-2018, 05:56 AM.

                Comment


                • #9
                  ok after a FIGHT against this machine here is what happened:

                  replaced the cap many times with different stuff..no change.

                  reflowed mux after removing edge bonding. machine worked fine for 15min. then dead. turned back on to:



                  reballed and worked fine.. for 30mins or so.. then it died again. completely. getting a quarter span left and right thing. repalced from a donor


                  and so far no crashes... will test many more hours and see if the mux was the cause

                  Comment

                  thread bottom ad

                  Collapse
                  Working...
                  X