For $29/mo, we provide access to advanced level technicians who will answer your questions on any Macbook board related matter to the best of their knowledge promptly & walk you through how to solve your problem so you can deliver a working board to your customer.
I injected ppbus to F7000 and you get pp20v and cpu vcore. So i changed u7000 still no luck. only 5v on pp20v.also found C6905 burnt and replace the cap. I get 3.3v on pin 1. but some time i get 4.5v on c6905 pin 1. by thst time pp3v3_g3h goes to 2.3v or 2.7v.
You mentioned correct 3V3_G3H in the first post.
What happened, that you only get 2.3-2.7V now?
U6903 requires enable signal from U7000.
CD3215 chips have various power rails, 1V1, 1V8, 3V3, 5V.
Even cannot get voltage on any, you still must check diode mode on all.
Compare readings between the 4 chips and look for any strange value.
I got first stage stable 3.3v on pp3v3_g3h. then I noticed 2, 3 times it went to 2.3, 2.7 v . now i get 3.3v stable. I get pm_en_p3v3_g3h from u7000.
on CD3215 i get 1.1v on c3204 , 1.8v on c3205, pp3v3_g3h and pp3v3)upc_ldo. But i dont get 5v in pp5v_s4_x_usbc. do we need s4 stage to get this?
I thought to give a note here as the fault is bit strange and hopefuly this will use for some other technician.
I got pp3v3_g3h 3.3v and diode mode also fine (0.325v)
Some times pp3v3_g3h droped to 2.7v so I injecked 3.3v pp3v3 and i get 20v on pp20v. but nothing on D6902 or R6902.
then with out injecking i get 5v on D6902 and the pp3v3_g3h. Finally i found what ever voltage comes to D6902 pin 1 & 2 out put is only 3.4v . Replaced D6902 solved.