Glenn
New member
Hello. I have got a 820-3462 motherboard whit light water damage and when i connect the magsafe the fan start spinning for around 2 second and then shut down.
whit out nothing connected the magsafe shows red light. sometimes after removing magsafe it use a couple of seconds and some times minute before it show red light .
on ppbus_g3h i get 12,58 volt (after i have power up and i measure in diode mode from F9700 its starts from -1.244 and goes piping all way up til 0.139 then stop piping) (diode i measure whit out power connected.) can somebody point me to the next step ?
add som pictures of the water damage area.
Thank you
Glenn
Update some more measurement:
PP3V3_S5: 3,3V
PPDCIN_G3H 16,66V Diode mode 0.657
PP5V_S5 5V
PPVRTC_G3H 3,3V
PP3V3_SUS 3,3V
PP1V05_SUS 1,06V
Update 2: Now it change from green to red)
whit out nothing connected the magsafe shows red light. sometimes after removing magsafe it use a couple of seconds and some times minute before it show red light .
on ppbus_g3h i get 12,58 volt (after i have power up and i measure in diode mode from F9700 its starts from -1.244 and goes piping all way up til 0.139 then stop piping) (diode i measure whit out power connected.) can somebody point me to the next step ?
add som pictures of the water damage area.
Thank you
Glenn
Update some more measurement:
PP3V3_S5: 3,3V
PPDCIN_G3H 16,66V Diode mode 0.657
PP5V_S5 5V
PPVRTC_G3H 3,3V
PP3V3_SUS 3,3V
PP1V05_SUS 1,06V
Update 2: Now it change from green to red)
Attachments
Last edited: