thread top ad

Collapse

Announcement

Collapse
No announcement yet.

820-2936 no image

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    I attatch magsafe, lid closed, fan start spinning, DOONG, 3.3v at pin 4, after a while fan stops, 0,063v at pin 4.
    Yes, I did PRAM reset. Tried 5 different LCD that works with other boards.

    Comment


    • #17
      Are you getting any voltage on C9020? LCD attached lid open of course. I'm running out of ideas on this one.....
      Also what caused the original damage around the ISL6259? Must have been liquid.

      Comment


      • #18
        0 volt on c9020
        I don't remember if there was liquid damage

        Comment


        • #19
          The LCD is definitely not recognized then. I have no idea why, but only thing I can say now is change the LCD connector...

          Comment


          • #20
            I don't have any new connectors. I'm gonna buy some from eBay.

            Comment

            thread bottom ad

            Collapse
            Working...
            X