goldcoastmick
New member
Hi guys.
Tricky one... I have a 12" board that appear is in S0 state but won't turn on. CPU gets HOT. Every rail and signal seems to be present...
I suspect it was zapped by a USB-C hub/dongle (Genuine charger but Unitek hub). Was working fine yesterday and today its dead. USB-C port on the hub smells burnt (but no visible burn), charger is still fine.
- PPVCC_S0_CPU = 1.7V
- PM_PCH_SYS_PWROK = 3.28
- PCH_CLK32K_PMIC is good
- PLT_RESET_L = 3.28V
Not sure where to go from here?
Cheers,
Mick
Tricky one... I have a 12" board that appear is in S0 state but won't turn on. CPU gets HOT. Every rail and signal seems to be present...
I suspect it was zapped by a USB-C hub/dongle (Genuine charger but Unitek hub). Was working fine yesterday and today its dead. USB-C port on the hub smells burnt (but no visible burn), charger is still fine.
- PPVCC_S0_CPU = 1.7V
- PM_PCH_SYS_PWROK = 3.28
- PCH_CLK32K_PMIC is good
- PLT_RESET_L = 3.28V
Not sure where to go from here?
Cheers,
Mick
Last edited:
