Recent content by andersonamr

Any updates on this case?

Alright. Made a really really dumb mistake, accepted the macos update, and now it won't boot, just stuck at the critical update page all over again.

When inducing sleep mode by macos, the behavior is the same. After 2 minutes in sleep mode, it restarts, but this time when it comes back, prompts to connect wifi and after, it shows the classic Critical Update warning. Turning it off and starting again, it's all normal. As i assumed before...

Would be a good idea to eliminate sleep mode? Is there any way to do that?

Both J's are well, measured, tested, both have the same readings. Both resistors and their traces, are perfect too. I don't think is about the lid sensors, it's more about what process are done when the sleep mode starts. It's good to note, it doesn't "reboots" immediately when lid is closed. It...

Is there anyway a can deactivate the sleep mode at all? Even when lid is closed?

Hi guys, i got this macbook pro A1707 board number 820-00928 which came in for liquid damage, previously worked by another shop. All around, i made it to work again after several points of damage where reconstructed. But now, whenever i close the lid/display, it starts to reboot. It boots...

Anyone would be able to help me?

Hi, i have this macbook pro a2141 512gb that came in with a dead nand. It's been to another shop, who removed U9000 and L9030 and U9080 from the board, so i removed the R5610 to deactivate this 01 wing function. Since it's 512gb, we have 5 nand configuration, 1 nand on the 01 wing and 4 nands on...

Hi, i got this macbook pro a2338, it had liquid damage that was cleaned by another technician before and got sent to me after failling to solve the problem, which is: Macbook has a chime, shows apple logo, starts the progress bar and then restarts. It repeats the same behavior for 3 times, until...

Alright, i'll not waste more time, thanks buddy! Already told the costumer his board is dead forever.

On a side note, the power outlet should be over 75w to start this macbook?

Injected 1.8v, also worth mentioning CPU gets mildly hot while cable connected. Is there any chance to measure igpu?

Hi guys, let's start the journey.... Costumer brought in this Macbook Pro 1708 Non-Touchbar that was stuck at 20v 0a. Measured F7000 and found PPBUS_G3H shorted to groud. Pulled out F7000 to confirm the shorted line, it was indeed PPBUS_G3H. Injected 1.8v, and found U7420 shorted by using a...

YAYYYYYYYYYYYYYYYYYYYYYYYYYYYY Yes, cd3215 was the same termination code. QB650 wasn't the fault by itself, it only had to take the USBC_TB_CC1 that goes through RB650 into the QB650 to work properly, which is created by the UB400/CD3215. It should've worked from the start, but making the...