Recent content by mitchell crane

  1. M

    What do you think about AOYUE equipment?

    Buy good tools if your going to do this for a occupation. I have a aoyue 852 and a hakko 810 ( recently purchased ). I never had much expectations out of the 852 and knew I would shortly buy a hakko/weller/jbc. The aoyue worked but it was easy to tell it was short on heat and air for large...
  2. M

    Recomended tools by Louis,

    http://www.amscope.com/microscopes/3-5x-45x-simul-focal-stereo-zoom-microscope-on-dual-arm-boom-stand.html This microscope would be more useful for working on boards. This is what I have. The boom will allow you to swing over any board and simul focal head will allow you to use the camera while...
  3. M

    JBC JT hot air station vs Hakko FR-810 station

    The interface on the Hakko does concern me as I do not like tools that make my work harder. When using a hakko soldering station it does not bother me as I really do not fiddle with it that much. With a hot air station needing more fiddling with the interface starts to weigh in more for sure...
  4. M

    JBC JT hot air station vs Hakko FR-810 station

    I am interested in opinions on this . It looks like the hakko has that same amount of raw power (actually more) then the JBC unit. Down side of course of the Hakko is the control interface which I am sure the JBC is much easier to control . Plus side of the Hakko is it is half the cost. So in...
Top