Recent content by Punkedthis

C'mon let the little guy shine for one time you shine for enough already. HAHa. I will find him... I will!!

Has anyone ever tried buying from UK or CHINA on smc pre-balled?? if there's some success stories, would you mind sharing the link and info? thanks..

what do you get on L7130 pin 1

while I'm not able to do any readings at the moment due to work, I will check to see if PCH even turned up on s5 mode which I believed is this rail -pp5v_SUS_PCH and this is the only S5 rail I see for PCH so if this is present I'm going to crossed out PCH as the fault as it's actually doing...

you can have a short but when you inject 12v on ppbus, how many amps/current is actually going in? 0.2a? 1a? 2a? or 0a?

no power on either side on pin1 and pin 2 and I turned off the light for complete assurance and nothing is cycling through the LED.

No Title

Always go in order from G3H RAIL or pp3v42_g3h PPBUS_G3H Rtc rail 5v rail, s5, s3, s0 3v rail, s5, s4, s3, s0 And so on..at least I did..

No Title dukefawks

Luckily just have just that in hand. will give it a shot. I know you're busy with 10,000 question everyday but with this pulse, what is the reason behind it if I do get a pulse compared to if I don't get a pulse? your reply will be much appreciated. I'm working on the led and resistor on a...

HAHAHAHHAAA!!!!!!!!!!:cool::cool:

but while waiting, I'm going to go ahead and post up U7200 pins readings... pin1: 0.0v pin2: 0.0v pin3: 1.99v pin4: 3.31v pin5: 2.03v boosting to 2.04v pin6: .77v pin7: 3.31v pin8: 3.31v pin9: 7.62 pin10: 3.31v pin11: 3.31v pin12: 0.0v pin13: 3.44v pin14: 1.99v pin15: GND pin16: 12.44v pin17...

dukefawks nada... nothing on both end. BUT on pin 1 of L7260 it's pulsing from .0001 to .0002 back to .0000....Sorry for the late reply. I'm still working a full 40 hrs job while doing this on the side.

Yeah I heat the SMC up twice with a crapload of flux and reflo good but seems like its the same. Guess I'll poke around u7200 for now

if you don't mind duke, a light low reading like ppbus_g3h (ex) PPBUS_G3H should be 12.8 but instead, on F7040 i get 12.44v what does this indicate? Is it a voltage drop that something along the line something is pulling it or.....am I just a over exaggerated prick? ALSO the same as...