Recent content by ton68

Removed c7111 tested diode mode on acin 008

Diode Mode ACIN 0.000 R7110 is reading 17.09v on pin 1 PPDCIN_G3H_ISOL and pin 2 CHGR_ACIN is 0 and its resistance reading 90k ohm R7111 resistance reading 1 ohm R7105 resistance is reading 1k ohm do i need to swap out R7110

U7100 with out battery 1 Chgr_agate 18.55 2 Chgr_DCIN 19.79 3 Chgr_ACIN 0 9 CHGR_AMON 35 mV 12 PP3v42G3H 3.36 13 CHGR_RST_L 3.32 14 SMC_BC_ACOK 1.5mV 17 CHGR_CSO_N 4.5 mV 19 PP5V1_CHGR_VDD 5.03 20 PP5V1_CHGR_VDDP 5.03 27 CHGR_CSI_N 0

I put the black lead on ppbus_g3h and the red lead to ground and get .129

Thank you I ran the wire and have green to yellow light but no battery detection. OS Monterey boots with power plugged in and battery connected but there is no battery icon. When check the battery capacity in terminal it shows 0. I downgraded to High sierra and still have the same issue. When I...

Sorry about copying the previous reply…I ending buying a new LIO board and cable and still no light or no 3V42_G3H on the LIO board which connections would I need to connect to bridge the issue and is there any measurement I can make to confirm what component is at fault…. Thanks again

Thanks you for the advice I don’t see any corrosion on the J9500 .. I replaced the LIO and cable with no success but it was a used item seller said it worked but who knows. With the board plugged in I measured on the LIO board pin 3 adapter sense if on j6910 and it’s 0… u6900 Pin 4 sys one...

Hello all, I need some help with this 2015 Macbook Air A1465 Board is a 820-00164. The computer boots with the power cable but only with the battery disconnected. Swapped out three different battery's which will work until the batteries die as they are not being charged. Removed from the...