Search results

Did you run ASD?

Kyle you must put your multimeter in resistance mode, then you put one wire in ground and the other one in pp3v42_g3h line (it doesnt matter where) and measure the resistance to ground of that line, measure it and post the value. Like if it were a resistor.

Congratulations on your new baby Repairable :)

Hi, I´ve checked SMC_RESET on u5010 pin 5 on diode mode and it is fluctuating like crazy but the other pins in u5010 are not doing crazy things. Do I have to replace it? SMC_RESET_L: 2-3.40V then 0V....something fluctuating SMC_BC_ACOK: 3.29V (U6901)

Steady and present pp3v42_g3h ppbus_g3h chgr_acin u7000 4v fluctuating pp5v_s5 PIN 16 U7200 12,5V So strange not present pp5v_s3 pp5v_s0 pp3v_s0 pp1v8_s0

Ok so now I have the smc I already change the smc for a new one, reballed, and the board do the same. Goes on....and then off again green light. What I have seen is that when I plug the charger with the battery at the same time it doesn´t appears the green light only 3 seconds instead of 8...

Yes, now it sounds everytime I turn it on! thanks Crizz Case closed :)

820 2375 board that it is working good (at the moment, cross fingers) but only chimes when reset pram if you restart or shut down...later... it doesn´t chime, but runs good. I don't care too much but I am curious. Anybody knows why?

No,I did a order of amtech flux to Louis and it came by USPS

He uses USPS

It is working perfectly, case close :) thanks Duke and Louis

Thank you so much Crizz. Very good post, I really appreciate this. Thanks again mate :)

Sorry guys but Louis is ignoring us since 2 weeks ago :)

I understand, so can I plug it in without any problem then?

Could you show or tell where the water damage was?

Really??I don't understand...why is the cap there and what is its function then?

the board is working good but I touched that cap and now it is gone :) I put my mail in private message thanks

Hi, I have a problem with an 820-2879 there was corrosion on a cap and now it is gone and I need to replaced it but I don't know the characteristics. it doesn't appears anything about it in the schematics. It is at the bottom of the chip

Yes, it is the same chip TPS51125

Thanks again Crizz, but what is the difference between direct heat stencils?