Search results

Yup I mean that. With "line up" on schematic.

ty aprendiz, so its indeed the other way around, first u7960 line up then q7950 ill check them thanks

no cpuvcore PP3V3_S0 present u7950 pin 1 0.021v pin 2 0.064v pin 3 0 pin 4 0 pin 5 0 pin 6 0 pin 7 0 pin 8 3.3 missing CPUIMVP_PGOOD missing ALL_SYS_PWRGD CPUIMVP_PGOOD comes from u7400 pin 46 5v 29 5v 19 5v CPUIMVP_VR_ON enables the u7400 chip CPUIMVP_VR_ON comes from...

came in with water damage around u7000 repaired some traces and replaced u7000. after that I took the board to Louis and it just turned on,,, around the right fan where its connected to the board the screw bracket is broken off. today I had some time and picked up the board again,. found a...

good. ty. next week would be great, its a customer board but he understands the issue is bigger (or I am less in the right direction, just don't tell him) week after that I am going to Ijsland for a week (he would like it if its back just before I go....)

Hi duke. did you get my message? how mutch for the checkup?

Apple says its a software issue. had a MacBook 2011 before, send it to apple and also asked them about this issue. they told me its software/firmware and its a diy

use the original tape, if you heat up the tape and put the iPad in clams it should work perfect. if not i ad a tiny drop of Bison max repair on each corner, just a tiny drop. and i never get any ipad glas back for comming off.

random measurements? does it chime,? have you got fan spin? liquid damage? known good screen and kabel? can you see apple logo when putting a light on the back of the screen?

out of body is no problem, hook up the speakers, the plugin charger, then short pins 5 see if you hear a chime. or if you hook up a mouse if the light turns on on the mouse See if you hear a chime is for the deaf people sorry for that, listen if you hear a chime.. gosh i am a dick

hi Duke, did you get the message?

i am probably gone say something stupid today.... I took out my rigol and normaly I can get the lines big inuf so I can see it going up and down somehow today.......pffffff pin 6 and 7 both vmax jump between 3,2v and 3,6v pin 6 and 7 both vavg jump between 3.02v and 3.06v pin 6 and 7 both vmin...

SMC_LID 3.46volt R5071 99.2k R6961 100.6 pram reset done twice now still no change also stil 0 volt on LCD_IG_PWR_EN checked connector looked good, made sure to replace it stil same

lcd works on other logic board. every pin on j9000 measure the same as on the working board. LCD_IG_PWR_EN stil no where to be found. bad GPU ?

thats the issue board came in cleaned....

oke got a second machine in just now, and that ones working I hooked up the board to that screen, but no luck still nothing

hmmm, finaly got the kabel in and back from vacation.. Best wishes for you all. pin 4 solid beep. pin 6 solid beep pin 7 solid beep.

hi all. Looking to Buy Hakko. But suppliers are short. Anyone using And bought Hakko in the netherlands of bought it somewhere else And had good experience?

0576 pin 6 0581 pin 7 connected pin 6 0.562 pin 7 0,502