Search results

Where the Heck am I going to find those 2 Mosfets!!!...lol...I have PLENTY of Metal Cased Q7180s....It?s the 1st Board I?ve seen like this...All of the 820-3332s, 3662s...00138s...etc All have the Metal cased One...GO FIGURE

I also checked C7185 and R7186 (PPDCIN_G3H) with DMM in Manual OHms mode and I Get OL on pins 1 of both with No Beeps?...Does that Help?

I just measured between pins 27-28 on U7100 and got 22.6Ohms with a Beep on the DMM...

Sorry I?m just confused as to what you mean by ?Check if one beeps with Power Connector (PPDCIN_G3H)? sorry I?m still learning...lol...Thank You for your Patience it must be annoying for you.

You mean check with No Power Connected Correct?

The top board in the photo is the 820-00426 and the bottom board is the 820-00138...As you can see the area is different...

[No message]

Thank You 2informaticos....Here are a couple of Photos of my 820-00426 Board...Where Q7180 (Dual Mosfet with Metal case) is Located on 820-00138, 820-3662...etc My Biard has 2 Black Seperate chips in that location...Since I Have no Schematic or Boardview for the 820-00426 I can only go by the...

Hi 2informaticos Thank You So Much Again for your Help!!!... I can?t seem to locate Q7180 on this 820-00426 board as the Boardview layout is slightly different on the 820-00138...So Frustrating...Do you know where I can get a 829-00426 Boardview? Some items are in the same location on the 2 But...

So I need to remove F7140 and then Take the Measurement ?...Sorry just a. Little Confused..lol

Didn?t mean to put a Question mark at the end:eek:

Okay I?ll do that ?

When I measure in This mode Diode Mode using Manual Setting it shows Ohms logo and with red probe on Ground and Black Probe on PPBUS_G3H I get OL reading...Does that seem Correct?

[No message]

Okay...I just get OL when in this mode....

This is the setting I Used with Red Probe on Ground and Black Probe on PPBUS_G3H...With No Battery or Charger connected...Is that Not Correct!

[No message]

Also L7095 Pin 2 = 3.42V Pin 1 = 3.41V

D7005 Pin 1 =16.20V (PP20V_DCIN_CONN_R Pin 2 = 1.04V (PPBUS_G3H_R) Pin 3 = 15.91V (PPVIN_G3H_P3V42G3H)

I also Measured D7005... Pin 1 = 16.20v Pin 2 = 1.04v Pin 3 = 15.91v