Search results

u7100 9 and 15 pin both zero V

L5001 is corroded, that give 3.24V to SMC, there was no connection to C5001, i fixed it with a cable but still same, to measue if connects to under the smc i hav eto remove again the SMC.....

with new smc it powers on in smc bypass mode, same as the original smc

i reballed the smc, then replaced it from donor board, same exact issue powers on 0.5A, fan spins, than dies, its not smc,

yeah, in SMC bypass mode it turns on and there is picture i will try to leave it overnight in full alcohol, maybe it can remove some crap under the smc, if that wont work i will reball it it, and have some donor board to replace SMC if needed to thx!

was bit water damage around smc R5180 R5179 replaced, it was working for few days, now came back -ultrasonic done, looks good actually -green light is ok on cgarger -fan spins once then dies -r7121 r7122 are ok 10ohm, that area is not water damaged - i can do smc reset -it powers on on for a...

yep, cpu is shorted

best type-c voltage/current meter for new macbook pro? Satechi USB-C meter is good? 30eur?

i dont have 32khz too 1/U1900 is 1ohm, that pin goes the the CPU, doesn it mean cpu is shorted?

i replaced u1900 and the 25 mhz chrystal again, same

so my u1900 is not giving 3.3V on the leg 1, so the crystals are not working? the leg 1 was corroded, i removed it, pad cleaned, chip replaced, but still no 3.3

in the meantime i found another good board, the measurement for this u7501 1 5.5 2 5.1 3 1.25 4 3.33 5 0 6 1.996 7 0 8 0 9 0 10 1.996 11 0 12 3.4 13 1.996...

fan is not spinning

i replaced u7501 (new chip)and u1900 (from donor board), there is green light, i can do SMC reset -the board takes 0.380A when i connect the charger, than that goes back to 0.200A and stays there i see no water else where, only on those 2 chips, and some resistors around, i replaced all of...

brand new a1286 gpu? last year i bought it from Duke, not sure if he is still selling it, i need a smaller amount

the single usb-c port was water damaged, water did not go further inside, even the cable connecting to is not corroded, i replaced the usb connector, now everything works fine but the usb communication, its dis charging fine when i connect a usb-c stick, which is very low consumption , i get a...

it actually works with PC-8500S 2x2 gb, customer upgraded to 2x8gb 12800, the max amount of ram is i think 8gb anyway this is an old core2duo laptop

yes, i have a good test hdd, just used in another macbook, and i replaced the hdd cable from usb it actually stuck halfway, on internal hdd it keeps restarting after about 1min of loading, and the line would reach abuot half way

was slightly water damaged in the middle area on the board, not that bad, it was turning on when it arrived here - than i put it in ultrasonic -did not turn on -after measuring around, seemed basically , so i reflowed the SMC, than it turn on again now, -i can do SMC reset, nvram reset, there...

haha, i reflowed smc, i actually poked it a bit to see if really melting, now charging