Search results

I was using the pads.

It still wont power on for some reason. What else should I check?

I have made more progress on this motherboard. I now have my 12V and 3V coils and am only missing my 5V coil after replacing U7200. What do you check to get 5V coil?

The fan would just stop spinning for a few seconds after it was turned on before then it would continue spinning.

Before removing D6905 the board was still powering on and the fan was spinning, just no image on the screen. Should I put the board in the ultrasonic cleaner again for the corroded resistors? I have a new D6905 to replace the old one.

No Title I cant get solder to stick to the pads I circled

Have a 820-2530 that had water damage. Ran in ultrasonic cleaner but after it would first turn for a few seonds, turn off then back on. I noticed D6905 had some corrosion which I scrubbed off then it would turn on with the fan at high speed, no image on the screen. After removing D6905 I...

Anything available that doesn't cost so much?

Will someone respond?

Whats a good bench power supply to purchase?

It was just 2 ohms

No it was f7000. Would like suggestion on how to proceed.

Also, I checked F7000 and am only getting 12.20VV, since its suppose to be 12.60V does this mean I have a bad smc?

I had 2.6 ohms

Can someone respond? I reported what I get for resistance to ground

I apologize, without power connected I get 2.60

Is there a simpler power supply for this procedure I can purchase to apply this power?

It appears I have nothing 0 on the resistance to the ground on this line

I checked all resistors that involve PP3V42_G3H and all of the voltages are present

R6929 is 3.3V