Search results

i was get this mac with x on the battery and service..i was replaed the battery it turn on but no charging..with battery it give 20v start few secound with 0.2a and drain to 0a all look fine, no short, mac stay on with just battery..witout battery the mac still show like the battery is...

Unfortunately he don’t have🤷🏻‍♂️

yes,the same.. after it shout off its show 5V 0A(PPBUS 12v) until i disconnect the battery and connect again and it turn on when i connect the charger..and the after the password enter its off again..

M1 14” with weird problem No water damage and not any looking damage.. Mac can work perfect and suddenly it crash and or not turn on at all, or after few minutes hours, it turn on just when charger connecting, get to the password slot, type the password press enter and boom shout off…try...

its the ssd

im sorry its 2.0-1.5OHM but no stable.. but look like the same as good board

if yes so its 0.11 same as good board

can i do it on F7000?

just the PPBUS and PPVBAT_G3H big coils gave this reading 293/5

293 diode mode

12.2v

no water damage, no AWAKE no SLPS2R voltage , no short found.. no ssd voltage and not short. replaced u7000 but the same..all 4 LDOs look o.k

didnt find something..but! i was injunct 1v to PPBUS to see maybe something will warm-up and yes! it was small cap with tiny crack..i was take it out and now all work! thanks!

sorry diode mode on PPVBAT is 500 and on PPBUS is 110

i get 12.3v on C5254 without F5200, but when i put new good F5200 again no voltage on PPBUS and on PPVBAT , no short found PPBUS without F5200 0.100 PPVBAT 0.300

5v on charger PPBUS 1v no short. all LDO look o.k

no water damage or seeing damage.... PPVIN_G3H_P3V3G3H low short 0.0756 should be 0.550 i was take out all PPVIN_G3H_P3V3G3H line (U6903/D6903/U7000 and some components) but still 0.0700...weird

O.k it was also problem with one of the memory stick.. Now everything work.! So for other that will fix this shi** few things. All the 4 power supply screws(silver) must be connected to get 12v on board. After replace/upgrade something and you see one led on, just do restore with DFU. 1# led is...

o.k i was put back the "old" u9000 now it pass DFU there is just 2# light, the 3# light is the memory sticks? or something else ?

I can’t *