820-3332 odd symtoms

ALB-Repairs

Member
My 820-3332 has 12.1V instead of 12.6V. The only noticeable thing that doesn't function properly is the power button. if pressed when the laptops on, it instantly restarts. When off it doesn't turn the machine on, you have to unplug the battery, plug in a charger and then hotplug the battery.
SMC_RESET_L is good.
I have replaced the SMC with no change.

SMC_ONOFF_L has 3v42 on it
Keyboard tested.

Ive figured its not doing a full SMC reset when the power buttons pressed either, SMC reset circuitry has been ruled out. The only thing i can see as obvius damage is long screw damage into the board where the Fan screws in (on the webcam connector side of the board.
 

Gurmon

Member
I seen this a few times on this board, always Q8930/Q8931. Pull the FET and check if its already burning a hole through the board.
 
Last edited:

ALB-Repairs

Member
I seen this a few times on this board, always Q8930/Q8931. Pull the FET and check if its already burning a hole through the board.

Holly Shit my power button functions after replacing those fets.

The fets i put on get pretty hot now so im not sure if they are safe to leave on there. Do They naturally run hot?

gobsmaked that replacing those fets restored my power button though, Good work!
 

dukefawks

Administrator
Those FETs have nothing to do with the original problem, use logic to figure out why. Also those FETs frying is because of bad soldering on the common problem child U8900.
 
Top