bighead
New member
Hi,
I've this liquid damaged board here.
There is green and orange light on the charger.
It does charge the battery.
PPBUS_G3H - 8.57V
SMC powers on.
PP3V3_S5 presents.
Before the repair the board was in S3 state.
ALL_SYS_PWRGD was missing and it was 125 Ohm.
I found PP1V05_S0 shorted. I changed U7600.
PIN 11 on the board was totally corroded so I fixed that with a jumper cable.
Also U1950 looked pretty pad so I replaced that one too.
Here PIN 8 was missing. I fixed that also with a jumper cable.
After this, the board went into the ultrasonic cleaner.
Now, looks like all the power rails come up for a second, but the fan does not spin.
The liquid damage was around the BIOS chip.
U7600 and U1950. Some was around the SMC.
I pulled the WLED driver because it looked really bad.
If I'm not mistaken Y1905 was oscillating prior the repair. Now there is 0.9V but it does not oscillate.
I also pulled the BIOS chip because PIN 8 was totally corroded.
Even without the BIOS chip fan doesn't move.
After this I reballed the SMC. Didn't help anything.
If I leave the board on the charger U7100 gets warm. I changed it just for the hell of it.
Any idea?
Thank you.
I've this liquid damaged board here.
There is green and orange light on the charger.
It does charge the battery.
PPBUS_G3H - 8.57V
SMC powers on.
PP3V3_S5 presents.
Before the repair the board was in S3 state.
ALL_SYS_PWRGD was missing and it was 125 Ohm.
I found PP1V05_S0 shorted. I changed U7600.
PIN 11 on the board was totally corroded so I fixed that with a jumper cable.
Also U1950 looked pretty pad so I replaced that one too.
Here PIN 8 was missing. I fixed that also with a jumper cable.
After this, the board went into the ultrasonic cleaner.
Now, looks like all the power rails come up for a second, but the fan does not spin.
The liquid damage was around the BIOS chip.
U7600 and U1950. Some was around the SMC.
I pulled the WLED driver because it looked really bad.
If I'm not mistaken Y1905 was oscillating prior the repair. Now there is 0.9V but it does not oscillate.
I also pulled the BIOS chip because PIN 8 was totally corroded.
Even without the BIOS chip fan doesn't move.
After this I reballed the SMC. Didn't help anything.
If I leave the board on the charger U7100 gets warm. I changed it just for the hell of it.
Any idea?
Thank you.