ytesfay80
Member
I have this 2011 MBP that was dropped on the charger port area so now it's bent and damaged on that area. The magsafe board needed to be replaced but I can not fit the new one into the port where it can charge properly.
Does anyone know a good way I can try to bend the aluminum frame so the magsafe can fit properly without badly damaging the frame?
Here are some images: https://www.dropbox.com/sh/ponngv33heu5h0d/AACs7QXyEYSI_Fb1DY-XiMjoa?dl=0
Does anyone know a good way I can try to bend the aluminum frame so the magsafe can fit properly without badly damaging the frame?
Here are some images: https://www.dropbox.com/sh/ponngv33heu5h0d/AACs7QXyEYSI_Fb1DY-XiMjoa?dl=0
Last edited: