thread top ad

Collapse

Announcement

Collapse

READ BEFORE REGISTERING SO YOUR ACCOUNT WORKS

In order for your account to be activated INSTANTLY, your PayPal email MUST MATCH THE EMAIL YOU USE TO REGISTER YOUR ACCOUNT ON THIS FORUM!! If your PAYPAL email address differs from your FORUM email address, your account will have to be activated MANUALLY when a customer service agent gets around to it.

I realize this sucks, and I do apologize.
See more
See less

820-00164 strange charging issues

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • 820-00164 strange charging issues

    I’m stuck, need some advice please. This board works fine on charger with no battery installed.
    With a charged battery and no charger it also boots and works fine.
    When battery is installed and you plug charger in, the icon says not charging the battery briefly then shows no charger connected, light flashes constantly until battery removed. Light then shows green then orange.

    Replaced u7100
    q7130
    q7155

    Changed a whole bunch of resistors around u7100 that were marginally out of spec and probably didn’t need changing.

    pins 27/28 measure 20ohms
    pins 17/18 measure 2.6ohms
    voltage at pin 2,19 and 20 of u7100
    tried new battery
    ppvbat_g3h_conn pin 5 is 16.1v no battery connected. Is 7.4v with battery
    r5422 and r5431 in spec
    acok is 3.4v

    Any advice appreciated.

  • #2
    "ppvbat_g3h_conn pin 5 is 16.1v no battery connected. Is 7.4v with battery"
    So F7140 has 16V on charger only...
    Seems that high-side MOSFET from Q7130 is shorted.
    When you connect battery Q7180 is blocked.
    Be sure pin24/U7000 is correctly soldered and C7125 is in place.

    Did you surelly soldered P-channel in place of Q7155???
    Check if is not shorted now...

    Comment


    • #3
      Yes f7140 has 16v on charger
      I just replaced C7125 anyway
      On Q7130 I have continuity from pins 2/3/4/9 to pin 10. This isn’t correct is it?

      Comment


      • #4
        Replaced q7130 again. Don’t have the continuinty to pin 10 anymore. F7140 is only 2v tho so I have something pulling it down I suppose.

        Comment


        • #5
          And now q7130 has shorted to ground again. Going round in circles.

          Comment


          • #6
            POS is fixed. Was either C7125 or I haven’t been putting Q7130 on properly. What a nightmare. Over 4hrs spent

            Comment

            thread bottom ad

            Collapse
            Working...
            X