Recent content by leonattpcs

My bad, I am passed the problem now and installing the OS after modifying the file to get rid of the password. Thanks again anyway

Ok I have the file, I have been told to look for $svs and delete it? Using a hex editor Neo and using control f, there isn't $svs in the file so what can be done now? TIA

OK thanks I will buy a new programmer or just adaptor and see what happens

This type of bios chip is new to me, I can't do anything, but learn at the moment. My EZP2013 doesn't have the right adaptor so will need a new programmer as well

So this thing?

Never seen bios chips look like that, I will see what I can find.

That what I took off is the only chip on the board that looks like a bios chip. I have bought one so will eat for that to see what it looks like.

The board is an 820 00430

That is a zip file, I couldn't upload the raw .bin file. The actual file is, I think, 1Mb in size.

OK, saved from the chip.

I can't get the software to detect the chip so I cannot get anything from it. Using the drop down links on the left hand side of the software, there is not manufacturer called adesto. Programmer I am using is EZP2013.

Hi, Customer has forgotten efi password, so I am trying to reset it. I have the refi chip removed from the board and had it in my high speed programmer, but where do I get a clean .bin file from to load onto it? Thanks Also the info from the chip reads: adesto1637 45db021e The programmer...

820 00138 - Computer not switching on found Q8020 burnt out so replaced, trying to switch on, no fan spin, then found short on pp3v3_sus. Before replacing q8020 the board was producing no heat at all. Injecting voltage, the main thing that gets warm is u1100 and the other side of the board. I...

I injected voltage there as that is where I found the short. 9ohms normal, so fine. If it is trash though, that is may answer. Looking for other things to try to learn more from it.

Hi, Has anyone got a board view and schematic for 820 00687. Water poured over laptop and now not switching on. Signs of liquid damage on board that I have attached to this image. The image with the highlighted caps I have found only have a resistance of 9ohm to ground and have found from...