Recent content by nikwest

Sorry, for the long silence. I have been swamped with work. I don't think I shorted anything, but I measured everything again. Status is like given in my first post. It also doesn't turn on with the PWR BTN pads.

Thanks, that was a good hint. I changed to the 85W charger and then when I shorted the pads the fans spun up for a minute. However they stopped again while I tried to measure the missing power rails. Now the fans not spinning up again and I am back to where I was before. PM_PWRBTN_L only goes...

Yes, I have 1.05V on C7771 Pin 2. I completely removed the logic board from the housing. No keyboard connected. However I just connected the board with the power supply, but did not manually power on the board with the pads. I just tried to do that now, but that did not change anything...

- I cleaned the board, there where some small areas where you could see a bit of liquid damage. After cleaning it looks ok. - Light from power adapter is green - Checked the following power rails: PPBUS_G3H: 8.4V PPVIN_S5_CPU_IMVP_ISNS: 8.4V PP18V5_DCIN_CONN: 17.1V PP3V42_G3H_REG: 3.4V...