Recent content by tipoti

I checked all the resistors. I changed the capacitors around it. The device gives 3.3v when it first starts up, it drops to 2.4 volts after 15 seconds. I removed the RC412-13, it's the same, what else can I check? I don't have a spare working card

Device liquid contact the customer disassembled the device and LP610 exploded. I replaced the LP610. The device turned on. It worked for 1 day, then the fan started spinning at full speed and would not turn on. When I checked, I noticed that the UC710 was also damaged by liquid and replaced it...

Yes, I already mentioned that the device turns on. I also provided the battery cycle count and capacity information. So yes, the device turns on but does not charge. It shuts down 1 second after unplugging the charger because the battery is at 1%.

battery cycle 275 capacity 86%

If the battery was broken, wouldn't it say it wasn't charging? There is no charging sign

No, I don't have a battery, is the battery broken?

Hello, Some water got into the Type-C port, and the sockets were in bad condition. I replaced all three sockets with new ones. The device turns on, but it doesn’t charge at all, and the charging indicator doesn’t appear. There is no other liquid damage on the motherboard or the device; it is...

When I run the Apple Configurator, the recovery screen appears and when I click on revive device, I get the 0XFAE (4014) error.

PP3V3_G3H: 3.2 volt PP1V8_SLPS2R :1.8 volt PP1V1_SLPS2R :1.1 volt PP0V8_SLPS2R :0.8 volt PP1V2_AWAKE :1.1 volt PP3V3_AWAKE :3.2 volt PP1V8_AWAKE :1.8 volt P1V1_SLPDDR_SOCFET_EN :1.8 volt

hello, There is no liquid contact. I did not see any damage. When I put the 20v 0amp battery in, it draws 1.13amp but the device does not turn on. There is no short circuit in the coils P5VG3S_VSW :5V P3V3G3H_VSW : 3V

UR600 bölgesinde vardı. Daha önce başkası tarafından temizlenmiş. UF400/500'in yanlarında sıvı teması vardı. Cihaz şifreyi girdikten sonra kapanıyordu veya ekrandaki renkler karışıp kapanıyordu. İkisini de söküp tekrar bilye taktım. Sonuç değişmedi. UR600 ısınıyordu, söktüm. Bazen açılıyor...

Hİ, I have a liquid contact motherboard. Sometimes the device turns on and sometimes lines appear on the screen and it locks and turns off. The UR600 was overheating so I disassembled it. I checked all the pins under it with gnd and I couldn't see any problem. My question is; Can I hear sound...

L7270: 1V L8102 : 0,9V L8100 : 1.2v LB700 : No Voltage L7702 : No Voltage L7600 : 5 L7660: 3 I tried revive/restore modes. The process is interrupted at stage 4.

ALL_SYS_PWRG6D8 _R : 1.7 Voltage

Hello, There is no liquid damage or anything similar; the board is very clean. It charges, and the fan spins. Without the battery, it draws 0.100A. In DFU mode, it fails at stage 4. The trackpad click works, but there is no voltage on L7430, L7420, L7410, L7210, and L7220. When I check for a...