Search results

I can't seem to get good contact with any of the pins on U7000. There's a bunch of sticky leftover flux crap that I can't seem to get out of this area, which is blocking me from making sold enough contact with anything to measure properly through. Any tips to clean it up? Q tips just rip apart...

I get 3.3 ohm when I measure at each end of c7050. Pins 17 and 18 wind up going there, so I figured it'd be easier to get my shitty multimeter to touch that than the pins themselves. I'm pretty new to this, so if that's just the resistance of c7050 itself and not what the SMC would be getting...

Replaced r7051 and r7052. Measured 13-14ish ohms from pins 17 and 18. I'm not 100% sure if that's accurate since the tips of my multimeter are shit, so i'm not going to attempt measuring the other set until I figure something out or get the tip extender things. What should I be getting from...

Kinda sounds like a dying hard drive. Victoria scan it?

I didn't manage to get a reading before replacing it, but I swapped out "one" of the shit resistors at the top of my picture (not near my computer with the schematic to tell me which one it was called), and now it's acting differently. Previously it was having trouble all the time, but now I...

No Title Yeah, the whole area is just kinda shit in general. Is this SMC the same specs on an older board? I have lots of 2010-2009 ones I can take things from, but unfortunately this is the only one of this exact type I have left.

Oh, woah, I don't know how I completely missed that area. There's about 6 corroded pads and a few resistors around there that are all sketchy looking. Thanks for the help! Not gonna be able to attempt to fix it tonight, but nice to know I at least have a place to look now haha.

First post on this forum, so excuse me if I leave something important out. Checked a bunch of other posts and didn't see anything related to this, so.... I have a mid 2012 board that only turns on if you hold the power button down. I'll get a small fan spin from a click, but in order to get it...