Search results

Hello, does anyone know a way around the function key mapping issue on replacement keyboards? This A1932 has a replacement keyboard but without access to the AST 2 server, I can't see a way around getting the function keys to work again. Just to be clear, the keyboard isn't faulty, its just...

With the battery plugged its pulling 20v 3.6a but I suppose thats just battery charging only as everything just stays pulsing

SMC Bypass does nothing unfortunately

Hi 2informaticos, thank you for your help. L7330 and L7960 are pulsing but the multimeter isn't quick enough to catch the peak (possibly 0.8v-1v). L8000 has nothing on pin 1 P1VS4_PHASE but does have 1v constant on pin 2 PP1V_PCH_REG_R P12V_SSD_VPP_SW & _L are holding at 0.15v and pulsing...

Hello, I have an 820-00928 with 20v and only 0.04a which jumps to 0.40a and back again every 15 seconds. No obvious signs of liquid and wont start on SMC bypass Testing board on the side only with only a dc in board connected, I get: PPBUS_G3H = 12.52 PP3V3_S0 = pulsing ALL_SYS_PWRGD =...

I've spent the last week trying to sort my sons brand new Acer laptop for a charging issue after liquid damage. Originally it wouldn't turn on but I found shorting caps on the 19VB_CHG circuit. Replaced those with the same and the laptop fired up fine, works on charger or battery but won't...

Can I take another bios chip off of the same board EMC 2554 to check that?

I've checked all resistors around the SMC including the other side. Took ages but it seems they are all okay. Is there any way to narrow it down?

All SPI Bus series termination resistors test as schematic. Traces look good, not sure what to check next. I have PP3v3_SUS

Pin 1 = 12.22v Pin 19 = 5.06v Pin 29 = 5.06v Pin 46 = 5.06v Pin 47 = 3.33v Pin 48 = 12.26

R7402 = 149k R7403 = 181k So they seem fine

also PPBUS_S5_HS_COMPUTING_ISNS is 12.45v

I have an 820-3115 liquid damage around SMC. Originally no magsafe light. Removed and reballed SMC, now I get magsafe and fan spin with the fan at full speed after 5 seconds. CPU has a little heat in it after a min or so. ALL_SYS_PWRGD = 3.29v PPVCORE_S0_CPU = 0.00v I'm stuck with this one...

Took off the pad, dug down and separated the short. It had burnt the fiberglass layers under it so bad that it was shorting under the pad. I've removed the short now and i'll attempt to run trace wires in its place instead

Unfortunately its a short within the layers under pad 1of C7220 :( Not sure if this will be fixable

It's pulling 2.42a @2v but nothing seems to be heating up

Do you think maybe remove U7410,20,30 to see if shorted?

Had to edit the last post as my readings were wrong

The closest to 0.002ohms are L7410 @ 4.8ohms, L7420 @ 4.9ohms and L7430 @ 4.9ohms. L7210-7210 are both at 10ohms. The rest are 60ohms on a couple and Kohms or Mohms to GND

0.002ohms PPBUS_G3H_CPU to GND