6 plus Meson and M1 jumper got touch working, now boot looping.

iphone 6 plus had M1 jumper installed and meson IC replaced did restored touch functionality. This was for touch disease repair. But I have a new problem:

Either cold boot right after plugging battery in or hard reboot using power and home button combo sometimes get into lock screen with touch working but would reboot few seconds later while trying to enter passcode then reboots then stay in boot loop.

If finally gets to lock screen, also I can just wait few seconds later then it will go into boot loop too.




Too much heat and now there is a bad contact somewhere. No way to tell really but around the area you worked in. This is going to suck as it can be anything.