This is an interesiting Case:
I2C lines are fine
feedback is fine
sense cuircuit had broken traces (to the shunt resistor)
made those connections again
the screen is working. I tested it
on the backlight output i have 11.7V
i have found out that if i measure r7702 on pin 2 (with a multimeter) the backlight starts working. So i changed R7702. But still the same issue.
I have also changed the following parts: u7700, D7710, Q7701, R7701, C7700, Q7700
i am a little lost. What could be the issue here.
I2C lines are fine
feedback is fine
sense cuircuit had broken traces (to the shunt resistor)
made those connections again
the screen is working. I tested it
on the backlight output i have 11.7V
i have found out that if i measure r7702 on pin 2 (with a multimeter) the backlight starts working. So i changed R7702. But still the same issue.
I have also changed the following parts: u7700, D7710, Q7701, R7701, C7700, Q7700
i am a little lost. What could be the issue here.
