PhilipC
New member
Tried with known good batt and tried its own batt in another machine.
Pin 4 of batt conn SMBUS_SMC_5_G3_SCL has a 3.3ohm (100k on known good board) measurement to ground.
Is it okay to inject 3.3v on this line to find the short?
Whats the best way of taking off the connector? there was corrossion surrounding it and the pin looks blackened.
I do have a replacement connector
Pin 4 of batt conn SMBUS_SMC_5_G3_SCL has a 3.3ohm (100k on known good board) measurement to ground.
Is it okay to inject 3.3v on this line to find the short?
Whats the best way of taking off the connector? there was corrossion surrounding it and the pin looks blackened.
I do have a replacement connector
Last edited: