nate8organic
New member
got in a soda damaged 2850 board, brought it back to life but i have no backlight. i did replace the lvds connector and pin 40-38 on ppvout_s0_lcdbklt pads seem to have connected together is this a problem? also how does ppvout_s0_lcdbklt get to that part of the board? pin 39 & 38 pads are also not connecting to the end of the pad they are only about half of the pad where the pins from the lvds connector are. was wondering if this might be the problem? if so where should i run a wire from? can i scrape back the board in front of the pad? or does it come from somewhere else? i checked bklt_en and its there. checked the fuse also good.
The only thing i notice on this board is that it takes a 10 seconds from plugging in the power until the chime and screen try to go on. i do have data. and it does boot all the way.
Thanks
Nate
The only thing i notice on this board is that it takes a 10 seconds from plugging in the power until the chime and screen try to go on. i do have data. and it does boot all the way.
Thanks
Nate