Recent content by jgraffis

  1. J

    820-3115 no wifi, Io0r error

    Not sure what im doing here either. have fun being a dick to everyone else.
  2. J

    820-3115 no wifi, Io0r error

    u5410 pin5 is 2.4kohm pin4 0.0kohm also.would seem pin5 has a bad trace?
  3. J

    820-3115 no wifi, Io0r error

    i do have 3.3v on PM_WLAN_EN_L, Ive got 0.135v on AP_PWR_EN. i checked and no short to ground on this line. it looks like PW_PWR_EN comes from XDP_DB2_PCH_GPIO10_AP_PWR_EN which is the same 0.135v. would this be an issue with the u1800?
  4. J

    820-3115 no wifi, Io0r error

    i will check traces and report back. this is the first time I've had a board with no wifi and it not be the card/cable/connector issue, hence why i chose to start by replacing the card and cable. i will check for pm_wlan_en_L and ap_pwr_en. also.
  5. J

    820-3787 Missing PM_SLP_S3_L

    PM_SLP_S4_L voltage present? if not this would suggest another problem.
  6. J

    820-3115 no wifi, Io0r error

    working on this liquid damaged 820-3115, after u.c. the board powered on but had no wifi, and left shift key not working, also io0r sensor reading above hight point. i got the shift key issue taken care of by replacing the keyboard connector. Io0R current sensor is reading 10.999 a -I did...
  7. J

    820-3332 power rails fluctuating

    ahhh i see. yea this one is just screwed im thinking. i never had one go all to shit while here and not messing with it. i think this rabbit hole is gonna just be a board replacement.
  8. J

    820-3332 power rails fluctuating

    46ohms. so not short to ground. not understanding why diode mode shows 0.004ohms?
  9. J

    820-3332 power rails fluctuating

    agreed. i did some checking around on the board and found that pin 1 of r9840 is shorted to ground. im thinking there is an issue with u1800?
  10. J

    820-3332 power rails fluctuating

    i would normally agree with you on that, had it been opened up before screwing up but thats not the case. machine came in we always power on to verify the customer issue if possible. Thats where it started going sideways. way before it even got close to a screw driver.
  11. J

    820-3332 power rails fluctuating

    CPU Vcore stays at 0.0v ALL_SYS pulsing for 0.03v to 2.9v
  12. J

    820-00165 / power on only if ribbon connector disconnected.

    I would check inside the connector and the ribbon very carefully. i've had some of these where something gets stuck inside the connector and either bridges some pins or screws up the ribbon.
  13. J

    820-3332 power rails fluctuating

    no ive already put the u8900 back on.
  14. J

    820-3332 power rails fluctuating

    do you think this could be a possible smc issue?
  15. J

    820-3332 power rails fluctuating

    sure thing. not sure whats going on with this board. i want to start looking at cpu vcore, but get to bios and its not getting what it needs just power cycles. kinda a rabbit hole for me.
Top