For $29/mo, we provide access to advanced level technicians who will answer your questions on any Macbook board related matter to the best of their knowledge promptly & walk you through how to solve your problem so you can deliver a working board to your customer.
If anyone could suggest me how i can troubleshoot it and test if it is somehow working that will be fantastic. The visual is good and i have microscope to look at the logic board, but if there any other way too it would be wonderful. Thanks!
Is there anywhere Macbook Pro 13 Retina 2016 schematics? The model is 820-00875-A. I got water damaged 2016 model and i want to fix it. It is so stupid that there is no light indicator that tells me if its somehow working...
dukefawks You are getting angry quite fast. First of all i have already answered your question. There is no need for getting angry. Check the page two for the answer.... if your not up to it. I will copy it for you. :)
No i have not. Now i measured it.
F7140 PIN 1 = 0.5 volts and increases...
I already checked the R7050. It is 10K Ohms and there was 0.1 volts. When i checked the R7050 with diode mode it was 2.116 from both sides. And J7050 is good. I have checked if there was under it corrosion but there was not.
I have checked the board under the microscope and have not seen any waterdamaged areas. The only waterdamaged area was near the battery connector. I have the 3476 brd file but if anyone has the correct one 4942 i can tell you what capasitor was bad, but i still replaced it with the new one.
R7005 PIN 1 and the same in other side. dukefawks can you tell me what to do? It does not make sense that in C7132 is 12 Volts and in the R7005 Pin 1 is under 1.5 volts... What should i do now? What to check?
Can you tell how is it possible that board has in some other areas 12 volts? Like C7132 in PIN 1 and Q7130 in PIN 2 that goes to PPDCIN_G3H_CHGR and its only the Battery that is plugged in not the charger...
So i checked those dukefawks and larossmann .
R7005 = 1.295 Volts
D7005 PIN 1 = 0.025 Volts
D7005 PIN 3 = 1.225 Volts
And i checked the resistors value and it was same as in Schematics. What should i look next?
This is new battery and the results are the same as before, even after replacing SMC.