Search results

i tried that. i made a backup beforehand. but i couldn't manage to solder on another module, despite the bga machine. In the end, the whole board stopped working. I then took another one for the customer and migrated his data.

ok, i will try another one

I got an A2779 which has a black display. External monitor works. I connected a working display that works fine. of course it has the ghost problem. So I thought the display was defective. I ordered two displaypanels then I disassembled a display of this series for the first time and replaced...

did u find something?

sorry, i was in vacation no still in diagnostic, would be great to find the problem it have to be in the board because the 2 nands for 2 tb i desoldered from this problem board straight in another good board and there running dfu without problem

yes, i changed to be able to boot from external device

I tried to get a ISO and tried this with VM VirtualBox but I do some wrong it dont want to start from the "disk"

i tried it with HighSierra beacuse i have an installation stick but start from external SSD with HighSiera shows the prohibition sign. Installation USB with High Sierra the same

is this anyhow possible without Paralells? thanks a lot

I checked now all landing pads from the 2 nands in diode mode, they are all with the values in the openboard data now i soldered the original back, run dfu revive, in this moment when it will write on the nands it is restarting (can see in amp meter 5V 250mA then load the software unzip the...

now i got a good 820-2020 board i soldered the 2tb NANDs out from the problem board and directly in the good board. nothing changed, all procedures the same in dfu comes the progress bar and seems all good so what the hell is in the board. is it possible that the nand power is bad from one of...

i swapped the nands and chose the 2TB version. i have done this many times but with this device i always get 4013 as an error in the dfu. the position is correct, i have checked this by desoldering and reading, the content is also exactly the same as the source file. Then I soldered the...

so in such a case, only theretical, is it additional needfull to replace the cpu?

ok, yes right. By the way. I have the same model where the client needs the data. if i transplant the ssd in same position from the (client with data) to this board. after this brisge os (revive) will i can read the data out? can have this sucess?

using restore i get the Error 0xFAD 4013, found theat: 4013 / 6 - errors indicate bad NAND Sysconfig or wrong position. that means for me i have to solder out the nands and flash with p13 the firmware, solder back and try then with DFU to flash the bridge OS is that logical for you?

using revive

got this A2338 with the exclamation mark after the start So i forced it in to the DFU mode 1. download system ok 2. copy ok 3. extrract ok 4. install ok and ends in error tryed rvieve and restore but in the end got Error 2006 0x7d6 (failed to restore device in recovery mode) the cable is a...

cant find any difference in the usb-c area, checked in diode mode and with mac usbc&edp meter checked with known good battery and out of the case and in the case, stucks on 5V all the time i replaced UF260 with the good working board but still the same, the good working board works with this...

yes, and i found out that the SSD was not NVMe, it was a PCI-E AHCI SSD

replaced now with the 4771 and a SATA SSD, that is working