Search results

PPVDD_ECPU_SRAM_AWAKE 0.702V

PPVDD_ECPU_AWAKE is 0.633V Removed L8200 diode mode on U8100 side is 0.525 while other side is 0.25 Is this bad M1?

C5250 voltage is stable at 12.33v What should be checked next?

bad U8100? diode mode MPMU_BUCK0_LXO/3 0.100 0.223 on good board

P_IN flucuates up to 0.430v AUX_DET 1.3V stable VDDA/P 5V stable EN_MVR - flucuates up to 0.465v AUX_OK 0.056- 0.890v A/BMON 0V

No luck entering dfu mode either

Replaced Q5230/40 but no change

Still waiting to hear back. Diode mode readings match a good working board. Is there anything else that can cause this issue?

Checked diode mode in those areas and all of the readings are very close to a known good board. What should be checked next?

Same issue is occurring with F5200 removed. C5250 voltage goes to 12.30v then drops to 0V while magsafe or usb-c is plugged in as they go off and come back on

Replaced cd3217 from known good donar but same issue. Diode mode around DF602 is .168 but normal good reading is .130 diode mode around DF622 is .130

Diode mode readings on all big coils look good as well.

This arrived with no liquid damage. Power cycles every few seconds. Board looks pristine. Checked all coils and do not see any shorts. When magsafe or usb-c is plugged in they both turn on for two seconds then off then on. All voltages appear as well. What should be checked next?

solved with new trackpad cable

cpu proximity is 136c

heatpipe #1&2 are 128C. Replaced U5850/U5870 but no change

Yes

This arrived with fans spinning fast and slowness. Replaced Q5852-Q5854 but no change. What should be checked next and which program is recommended to find which sensor is at fault. Trackpad works as fine

different m1 board. cd3217 needs to come from only 02016 then?

Arrived with a burnt CD3217 and usbc amp meter going on and off every few seconds. Second port stays on at 5v Replaced bad CD3217 from a donar M1 board but same issue. What should be checked next?