Search results

Only injected around .7v the board didnt take anything more than that even for the first time. Coils ended up going down to 0 ohms after waiting a while. if cpu isnt dead wat should i do next

L74(10,20,30) all had less tha 1ohm to ground removed corresponding u74** and no short on ppbus anymore. Ppvccgt_s0g is shorted which i assume was responsible for the 3 coils. That line just goes to the cpu and some caps could it be a bad cpu?

What is considered a high side mosfet? how do i check if they are shorted and what do i compare big coils with

I have a 820-00840 board that has no power, originally customer said it was working and suddenly stopped after a restart, no liquid else than a bit on the ssd connector, put it through the ultra sonic and seems clean. pubs_g3h is shorted to ground with less than 1ohm to ground and shorted to...

Which ones do you use right now that work properly?

Ok just had another board like this a while back was just curious Thanks

Pram reset didnt do anything. its not too noticable but when holding the brighness up or down button its not as smooth as it should be not too much of a problem but just wondering. Its not letting me upload a gif its saying too large its around 3.7MB

I have a 820-3437-B works fine except when adjusting the backlight brightness it jumps from one brightness setting to the next. Its jerky/choppy vs being a smooth transition. I replaced the backlight chip and no change.

I think I'm going to leave this for now until i get time to do that thank you

Cant remember liquid it has been cleaned but there were bad components near u5620, replaced them and the chip, no change, no signs of corrosion I've went over the board a few times. Its been left on a shelf with some other boards for probably a month or 2

looks like i had r7102 on the board removed it and r5100 was bad replaced and got green light same problem still no chime/boot

Just tried new bios and same thing. I had a file that had clean ME and programmed it over the old one

I used a file that had a clean ME and it booted and worked before this happend ( it used to get stuck loading) Im not too sure what you mean by checking SPI Bus series, if you mean the resistors near the bios like r6120 they all have the proper resistance and if you mean "is there continuity...

I have an 820-00165-A board originally got stuck halfway through boot, replaced bios and it worked properly. After checking on it a few months later it now has PPVCC_S0_CPU at 1.8 but doesn't chime/boot and no image, cpu does get slightly warm, takes around 5.5 watts a little over 250mA.