Search results

I am not too sure I meant to type .

Just a quick update, I am too sure if it's the battery or I was testing using a 87W charger , I went back to review the area of U7000 And I proceeded to replace R7061 , C7023 ,C7020 as well as U7000 , Now the device behavior while on the USB Amp Meter is staying without battery disconnected...

any suggestions?

U7800 LDOs, SLPS2R and AWAKE voltages are exact comparing to the schematics, I noticed that C7020/3 Those are looking washed away but not shorted , should i go ahead and replaced them ? also U7000 Was replaced by a new chip , You think replacing it by another one reballed from a Donor would...

Will do that.

I have not tried to put it in DFU mode yet , I ran another inspection under a Thermal Camera U 6960 is the one blinking off and on , Would that have anything to see since i am still getting the 20V at the USB Amp Meter?

I tried a 96W charger and i am still getting the same behavior of Amp meter restarting.

Great , i will definitely do that and keep you posted.

I was doing a quick vision inspection i can see that C7029 and C7026 the tap cover is broken but they have good resistance to ground , would that be part of my issue?

I have a 87W Charger would that cause my issue? PPBUS_G3H with /without battery unstable since Amp Meter keeps restarting , when promptly connected i am getting 12.2V then going down to 5.2V when Amp Meter goes off 3V3_G3H_RTC is stable with and without battery Battery

All the USB-C ports has the same behaviour , one thing that i noticed when F7000/1 is off the board the device is stuck on 5v but not restarting on the amp meter , I have checked the coils on diode mode comparing to the schematics value , they are all fine but because of the restarting...

I have replaced R7015 I get my 20V now but the USB meter keeps going off and on i have made a short video on this link below, to see what happened.

Ok Great , some of the new Chips they are garbage I can tell. I will try that tonight and get back to you .

Will definitely try that , but U7000 was already replaced by a new one , I have a quick question for you , sometimes those new U7000 chips they dont work , would a reballed U7000 work?

With F7000/1 Removed, C7050 = 0.166v P_IN =5,19V AUX_DET= 0.060V SMC_RST_IN =0.032V VDDA/P=5.04V AUX_OK can't find it anywhere on the boardview EN_MVR= 0.00V A/BMON= 0.00V

Hello , looking for some help here, this macbook came in a cup of coffee dropped on it , I found serious impacts on the back side of the T2 chips also the area of U7000 Chip, its stock on 5V on my amp meter PPBUS-G3H diode mode reading is fine but when checking the voltage i am only getting...

Ok Thank you very much .

Really , do you have any tutorial for the flex gate ?

can that be repaired or should i just get a whole new screen?

Just to give you a heads up, in fact the lcd is my issue , I did the test with my A1706 lcd And yes backlight system works perfectly fine.