This customer attempted a battery replacement themselves. They damaged J4800 so I needed to replace it. Once I got it soldered to the board, I noticed the pads from PIN 8 and 12 were loose from the board. I'm looking at the boardview and I don't really see a good way to jump these two pins. How would you do it?
-
For $29/mo, we provide access to advanced level technicians who will answer your questions on any Macbook board related matter to the best of their knowledge promptly & walk you through how to solve your problem so you can deliver a working board to your customer.Subscribe Now
820-00165 need advice on this repair(jumper needed)
- Thread starter tawnytim
- Start date
Use tiny enameled copper wire.
I prefer 0.03mm for such kind of job.
Once done, fix the wires with UV curing glue.
I prefer 0.03mm for such kind of job.
Once done, fix the wires with UV curing glue.
Last edited: