myiannakou
Member
Liquid damage on LCD connector but only where it connects to the screen not on the logic board. Tried a replacement screen and also replaced the cable as it was seriously burnt / corroded but no luck.
Only one of the USB C ports works at the moment the other one just keeps blinking the AMP/Volt meter.
I get output to an external screen but no video on the built in LCD ( I think there is backlight but no video)
What should I measure as I am at a loss.
Thanks
Only one of the USB C ports works at the moment the other one just keeps blinking the AMP/Volt meter.
I get output to an external screen but no video on the built in LCD ( I think there is backlight but no video)
What should I measure as I am at a loss.
Thanks