-
For $29/mo, we provide access to advanced level technicians who will answer your questions on any Macbook board related matter to the best of their knowledge promptly & walk you through how to solve your problem so you can deliver a working board to your customer.Subscribe Now
820-01987 dead
- Thread starter BlueGold
- Start date
That means PPBUS_G3H is not properly controlled.
U7000 needs to communicate with T2 for this.
You may have a problem with I2C battery bus, or T2 corrupted software.
Try DFU revive first.
If no important SSD data, go for restore; if revive didn't help.
If can't enter DFU, check if all AWAKE and SLPS2R voltages come on; at corresponding small coils around U7800.
U7000 needs to communicate with T2 for this.
You may have a problem with I2C battery bus, or T2 corrupted software.
Try DFU revive first.
If no important SSD data, go for restore; if revive didn't help.
If can't enter DFU, check if all AWAKE and SLPS2R voltages come on; at corresponding small coils around U7800.
Did you follow all the steps from DFU tutorial?
You can use SE032 pads.
Did you force it correctly?
Must close it before connecting charger and maintain the short several seconds.
Must close it before connecting charger and maintain the short several seconds.
i think i did all correctly. I short 1V8 to Force DFU and connect typ C cable to host macbook. I did one more measurement and noticed that the macbook havent voltages when the battery is connected. What do you think about that? I have only when the cable is connected.
Last edited:
Connect both charger and battery for DFU.
Some machines don't complete DFU without battery.
Be sure to use dedicated USB-C port for DFU.
Some machines don't complete DFU without battery.
Be sure to use dedicated USB-C port for DFU.
Hey i have some news,
I solder the old U3100 Chip and now i have dfu. A lot of terrible chips are on the market. Pretty unlucky.
So now i tried to restore the macbook and i got amrestoreerrordomain – 0x6 (6) Error.
Do you know whats wrong now ?
i read that it can be the nand chip.
I solder the old U3100 Chip and now i have dfu. A lot of terrible chips are on the market. Pretty unlucky.
So now i tried to restore the macbook and i got amrestoreerrordomain – 0x6 (6) Error.
Do you know whats wrong now ?
i read that it can be the nand chip.
G3S and SSD voltages try to appear in the DFU process?
Or they are already present?
Or they are already present?