Hi. I have an a2338 with liquid damaged. For the most it was minor and cleaned up relatively well. Now the issue is the battery icon has an x when logged in. System report says 0 cycles and service recommended. Fan speed is normal.
Im still pretty new to m1 stuff so here is what i know so far-
Battery connected
Ppvbat_aon - 11.6v
Ppvbat_aon_charger_reg -12.01 v
Ppvbat_aon_chgr_r - 12.01v
Sys detect - 3.3v
I2c_smc_pwr_3v3_scl-2.2v
I2c_smc_pwr_3v3_sda-3.1c
When battery was disconnected i checked chgr_bgate and it was 12.01v
So there was liquid damage on j5151 on pin 2 and 7 and then had detached. I solder them back and some liquid near u5200 so cleaned that and checked for any shorts. None detected.
Also diode mode to ground on sys_detect_l and it was 0.404.
What should i do next?
Im still pretty new to m1 stuff so here is what i know so far-
Battery connected
Ppvbat_aon - 11.6v
Ppvbat_aon_charger_reg -12.01 v
Ppvbat_aon_chgr_r - 12.01v
Sys detect - 3.3v
I2c_smc_pwr_3v3_scl-2.2v
I2c_smc_pwr_3v3_sda-3.1c
When battery was disconnected i checked chgr_bgate and it was 12.01v
So there was liquid damage on j5151 on pin 2 and 7 and then had detached. I solder them back and some liquid near u5200 so cleaned that and checked for any shorts. None detected.
Also diode mode to ground on sys_detect_l and it was 0.404.
What should i do next?