820-2390, PP5V_S3 stuck on 1.6v

[yobad]

i have 820-2390, PP5V_S3 stuck on 1.6v.
i replaced Q7220 but no change

 

[2informaticos]

3V3_S5/SUS and PPBUS_G3H correct voltage?
What about PM_SLP_S4_L level?

 

[yobad]

PPBUS_G3H 8.2v
PM_SLP_S4_L 0v
3V3_S5 3.3v
what is SUS ?

 

[JohnB8812]

8.2 is too low. SMC_RESET_L voltage?

 

[yobad]

SMC_RESET_L 3.4V
I reflowed SMC

 

[2informaticos]

PPBUS_G3H still 8.2V?
That's no good..
If yes, check voltage and diode mode to ground on SCL/SDA lines of battery bus.

Do you get Magsafe green light, without battery?

 

[yobad]

i have a green light on MagSafe without battery and with the battery, it goes orange
SCL/SDA 0.502

PPBUS_G3H still 8.2

I already rebelled SMC
the logicboard consuming 0.12a without the battery, after plugging the battery it goes up to 0.8a
I think the battery charging

I put a photo with a thermal camera, U7000 get hot

 

[2informaticos]

Does it start in SMC bypass?
Try other ISL6259 too.

 

[yobad]

yes it started in ?SMC bypass, i already replaced the ISL6259

 

[2informaticos]

So you have correct PPBUS_G3H now.
Maybe before too, but you've measured on wrong point...

Did you change C7771?

 

[yobad]

Just replaced C7771, I found that the keyboard had a problem. When I plug the flex in the motherboard it stop charging the battery. The power consumption of charging drop to 0.02a

 

[2informaticos]

Check 3V3_S3 and SMC_ONOFF_L when KB is connected.