danezul123
New member
Hello everyone, i''m Daniel, new to this forum although i've been watching Louis videos on YouTube for a while now.
I have this 820-2915-b wich had EFI password.
Trying to get rid of this password i've copy bios information from a working board (same number) and write it on the "bad" board without any issues.
Now the board starts with a quarter fan spin for a second and then the fan runs normal. No image, no chime.
I've put back the bios info (bin file) wich i've previously saved, again with no issues but the board refuse to give me an image or a chime.
Everything appears to be normal, all the rails are present,the components gets normally hot.
I did this flashing without removing the bios chip from the board.
Could this causes some damage to the board?
The good board from where i only did the reading still works fine.
Any suggestions?
I would much appreciate!
I have this 820-2915-b wich had EFI password.
Trying to get rid of this password i've copy bios information from a working board (same number) and write it on the "bad" board without any issues.
Now the board starts with a quarter fan spin for a second and then the fan runs normal. No image, no chime.
I've put back the bios info (bin file) wich i've previously saved, again with no issues but the board refuse to give me an image or a chime.
Everything appears to be normal, all the rails are present,the components gets normally hot.
I did this flashing without removing the bios chip from the board.
Could this causes some damage to the board?
The good board from where i only did the reading still works fine.
Any suggestions?
I would much appreciate!