820-4924 doesnt run from battery

[BCN_Techs]

No water damage, Just stopped charging (no green/orange light)

ISL625 pin 17/18 resistance was wrong so i replaced it, also R7151 ( value was wrong).


Now MacBook boot, i have green and orange light but when unplug charger it takes about 3-4 seconds and computers sleeps.

PP18V5_DCIN_CONN_R is 15V
PPBUS is 12,2V

Also replaced Q7130 but no result.

SMC is dead?

 

[BCN_Techs]

R5381 must be 2K OHMS but it is 15 OHMS . Replaced it but still same value.


Diode mode:

SMBUS_CHGR_SCL = 0,003
SMBUS_CHGR_SDA = 0,497

 

[2informaticos]

R5381 was probably good.
The short on the board have put you into confusion.

Remove D7050 and check again SCL line.

 

[2informaticos]

Remove U7100 and check again diode mode on SCL line.
If still bad, then probably need to change SMC.

 

[BCN_Techs]

it was SMC. replaced and all is ok now


thank you


P.S: Is there anyway to reprogramm SMC??? I got first from 820-3476 board (similar, but not same) and everything was ok but it was detecting 42 inches display and resolution was over 2500px.

 

[2informaticos]

 

[BCN_Techs]

Thank you very much. this week will try flash it.

 

[BCN_Techs]

Flashed, thanks