ereddekopp
New member
This system came in for liquid damage...was not turning on. It powered off the power pads. I replaced the keyboard and trackpad....they took the bulk of the liquid spill damage. There wasn't much on the board itself, but ran it through the ultrasonic (setup per Louis' instructions) just to make sure. So after repair and reassemble all was perfectly and working normally. Customer came to pick it up and system would not power on. In the back it goes again, another trip to the ultrasonic, works fine again and is booting from the battery. Guy comes back in again and again it won't power up.
Where I seem to be at is, the system powers fine connected to the magsafe, it also sees, charges and will run off the battery...but will not boot from the battery...not even a second battery I tried.
Just was wondering where to start with this to track the issue down?
Where I seem to be at is, the system powers fine connected to the magsafe, it also sees, charges and will run off the battery...but will not boot from the battery...not even a second battery I tried.
Just was wondering where to start with this to track the issue down?