ytesfay80
Member
This board initially was just a no backlight issue and there was liquid damage around the entire lcd connector area as well as the lp8550. I replaced all the components in those areas and after all this now the fan does the usual on and off fan spin 3 times but after about 1 second the fan stops spinning. PPBUS_G3H is 8.6v and once the fan stops spinning o 5v_S5 and 3v3_S5 rails are present.
There was also liquid damage to the JTAG connector which I removed. I thought the issue for this fan spin may have been because I found that Pins 30&34 of J6100 were bridged together but even after fixing that the issue remains.
C5120 did not look good so I replaced it along with U5110. All the proper voltages are present on U5110
I replaced C5003/09 because they didn't look to well.
There was a little corrosion around U6100 and U1900 so I put some flux and heated that area.
U1950 and its area looks fine and I get 3v42 on C1950 even when the fan stops spinning.
It is doing all of this with no external components plugged in.
There was also liquid damage to the JTAG connector which I removed. I thought the issue for this fan spin may have been because I found that Pins 30&34 of J6100 were bridged together but even after fixing that the issue remains.
C5120 did not look good so I replaced it along with U5110. All the proper voltages are present on U5110
I replaced C5003/09 because they didn't look to well.
There was a little corrosion around U6100 and U1900 so I put some flux and heated that area.
U1950 and its area looks fine and I get 3v42 on C1950 even when the fan stops spinning.
It is doing all of this with no external components plugged in.
Last edited: