mbcontrol
Member
I'm working on a 820-00165-A that came in with water damage. After fixing this the board now behaves as follows:
It starts normally when booting for the first time. After that it always gets stuck at approx. 223mA.
If it has been off for a while, it starts up again normally for one boot process. Then again stuck at 223mA ...
I measured all Power Aliases from page 62 while it stucks at 223mA - they are all good.
Can you give me a tip on how to continue troubleshooting?
It starts normally when booting for the first time. After that it always gets stuck at approx. 223mA.
If it has been off for a while, it starts up again normally for one boot process. Then again stuck at 223mA ...
I measured all Power Aliases from page 62 while it stucks at 223mA - they are all good.
Can you give me a tip on how to continue troubleshooting?