820-02098 water damage, no PP5v_S2_MAIN

devoniodd

New member
All LDOs out works (both U8100 and U7700) except for 3V3_AON, could not measure the coils, I can't reach the contacts porperly, I'll get nwe probes. Any idea on how to get a new U8100?
 

2informaticos

Administrator
Staff member
"All LDOs out works"
I don't understand.
You've said no 3V3_S2, which is LDO1 of U8100.

Need to get U8100 from donor board.
 

devoniodd

New member
So I think I found a replacement for my U8100. I thought don’t understand if/how the absence of 1V8_S2 and 1V2_S2 could be caused by a faulty U8100 and if not so what could be the problem. Also as you pointed out U8100 has some platform-dependent pins, what exactly does that mean? I found a A2442 donor board which is the same model, but not sure if it’s a 8/14 or 10/16 cores, could that be a problem?
 
Last edited:

2informaticos

Administrator
Staff member
If is same model, is the same platfom, so you can change it.
U8100 is master PMU and must generate 3V3_S2 by itself, without an external control.
It only needs 3V8_AON to generate 1V2/1V8__AON and 3V3_S2.
Also generates 1V5_AON for its core and 1V8 for SRAM.
 

devoniodd

New member
Ok, my problem is that they seem glitchy, a jumping tensions (always under 200mV). Can the be caused by U8100 on 1V8_S2 even though it is generated by U7700? Or is this a sign of a faulty U7700?
 

devoniodd

New member
I replaced the chip but still got the same error. The U8100 gest input and I have 1.2 and 1.8 railer but nothing on the 3.2V
 

2informaticos

Administrator
Staff member
If 1V2/1V8_AON are both present, PP3V8_AON_MPMU_ISNS is surely present.
Then 3V3_S2 must be there too; unless is shorted to ground, or has lower resistance than normal.
Possibly bad solders.
In fact, all LDOs derived from PP3V8_AON_MPMU_ISNS, should be there.
 
Top