820-02100: Not powering up

[repMacFixit]

Got this board that came in due to liquid spill and no power. Found UG400 and UG800 blown. Replaced to confirm short was gone which it did but something strange is happening; when usb-c is connected to JG600, i have no 5V on FG200 or FF200/FF201. I do have 5v on PPVBUS_USBC2. When connect power to JF600 or JF601, i have 5V on FG200 as well. I can't seem to figure out why this is. Any suggestions?

 

[2informaticos]

All fuses are connected on the output side of the CD32x chips.
You have a problem on UG400 area...

 

[repMacFixit]

went ahead and pulled UG400, check for continuity to FG200(2) and all connections were good. Replaced all the usb-c chips again with the same result

 

[2informaticos]

Why to replace all?
Compare diode mode readings around UG400 with UF400/500.

Did you replace burnt CD3217 chip with one from same model board, maintaining its position?